27
2017.06How to use wax annatto furniture maintenance maintenance and how to defend?
You cruel at that value and appreciation value and preservation in the integration of annatto furniture because of bad maintenance become a makeover?Use demand Below, we specific to understand the use of annatto furniture maintenance wax process under. Here let's brief to introduce annatto furniture maintenance wax curing process, first, we need to do is to point wax, annatto furniture maintenance wax evenly on both points in furniture appearance, the first is to in the back of the brush can be maintained in the process of wax candle even alter in any part of the furniture, make each part can get abundant maintenance.Process 2: The wax on general plane, only needs a shovel head can be smooth, but about some hollow out type may have run out parts of the other, selected wax shovel the demand according to the actual situation.Finally USES pure cotton swab along the lines of furniture, to ensure the strength and speed in the process of scrubbing, so wash back furniture more luster. Now we brief introduction to the use of annatto furniture maintenance wax should pay attention to some of the items, the first demand note is drying of wax must complete penetration into the wood, prevent the formation of unnecessary abuse, together in the whole process, the temperature of the heat gun also demand control is in order, avoid damage to the internal structure of the family property, and in the end, also furniture shall be careful to maintain, away from fire, heat, water, and so on.To distinguish the tips Good wax color is gorgeous, and highly resilient, usually in the melting point of 62-62 degrees Celsius, at the same time, if use nails to push wax, wax on the surface of also won't have the necessary instruments, with teeth to bite into lit chips, non-stick teeth, in addition, wax also has a unique flavor.27
2017.0627
2017.06How to annatto furniture maintain candle?
Because is wooden, which is influenced by water cut and so on, obviously, annatto furniture maintain candle when the moisture content of wood furniture is lower than the outside world, will absorb the moisture in the air, which can make the furniture, burst, the water for a long time, and time will slowly moldy.Protection woodiness furniture has a lot of, or isolation, or reduced, often ventilated breathe freely, clear clean. In the process, need to use a heat gun, but in the use of hot air gun, temperature not too high. Third, is the wax.In the process of heating, make the wax, wax slowly penetrate into the material of furniture. In the process, need to use made of ox horn traditional tools, namely wax wax scraper commonly known as screwdriver.The uneven places, also can use sand paper to wipe.Step 5 is to brush the wax.Wipe wax is to remove the furniture surface has no clean shovel wax to, in order to achieve the furniture surface feel is intuitive, wax, to make the surface could not feel sticky. Shake wax, with pig hair brush, is commonly used 7 to 8 cm wide, 12 to 15 cm long and hardness, good black bristle brush.This is the last step, do good, the surface glossiness can be reflected.